HBS24-12A Smart Instant Hot Water Recirculating Pump System – 3-Speed, Built-in Thermostat, 145 PSI, 24V DC, 6.6 GPM

Welcome to PROZRTED instant hot water recirculating pump system, where we provide the most advanced built-in thermostat circulation pumps and accessories which can help to to save the money on the water and energy and save the time on waiting for the hot water. Products certified to NSF/ANSI 372 conform to the requirements for "lead free" plumbing products as defined by California, Vermont, Maryland and Louisiana state law and by Section 1417 of the US Safe Drinking Water Act. Advanced high flow and high lift smart pump. Built-in thermostat. Advanced motor technology. Maintenance-free. NSF certified. Safe for drinking water. All these advantages promise you a reliable instant hot water solution.

• Smart pump. Three modes are available. Smart constant temperature mode: Instant hot water always available. Energy-saving constant temperature mode: If you don't use the hot water for some time, the pump will decrease the temperature setting point automatically. Manual mode: the most energy saving mode, just start the pump few minutes before you need the hot water. Smart memory function. 3 running speed. The pump can remember the last settings when it was powered off. Work well with smart plug.
• HBS24-12A hot water recirculating pump (maintenance-free) was designed to be installed on the backwater pipe to the water heater. Built-in thermostat. Maintenance-free.3/4" NPT. NSF certified. Lead free grade copper pump body. Safe for drinking water. With 10 ft cord and easy to install. Max. liquid temperature is 158 ℉(70℃).
• Can work with tank less and tanked water heater. Super energy saving application recommendation: Set the pump in “manual mode”. Start the pump by push remote control middle button. The pipe water will reach the setting temperature in few minutes. And then the pump will shut off in 60 minutes. There will be no 60 minutes extension if you start the pump by the pump “HAND” button. Care your water heater (Longer life no more frequent start). Save gas, save water.
• Advanced high speed recirculating pump. High flow (6.6GPM/396GPH max) and high lift (39.3ft max). It only takes a few minutes from turning on the pump until the hot water in the pipe reaches the set temperature. Advanced permanent magnet brushless 24v DC motor makes the pump more safe, more powerful and more durable. Super quiet pump and you almost can’t hear the pump running voice. Up to 10% of your water bill will be saved. Instant hot water when you need it. No more water wasted in waiting.
• Built in check valve. The pump default temperature is 38 ℃ off and 33 ℃ on. When the water temperature in pump is below 33 ℃ (91.4F), the pump will push the cold water back to the water heater. As the temperature hits 38 ℃(100.4F), the pump will shut off automatically. Remote controller was used to set higher or lower water temperature (From 32 to 42 ℃ ). This remote controller is not included in this package and needs to be purchased separately.
• Two advanced built in high accurate temperature sensors (One to measure the pipe water temperature and the other one to measure pump ambient air temperature). Protect your pipe from freezing. Make your installation easier. Save your time (One installation position). To avoid any water leaking, please make sure the plastic washers were not damaged and were installed correctly. Max. liquid temperature is 158 ℉(70℃).
• 2 year limited warranty with satisfactory solution. If you are not completely satisfied with our product, please feel free to contact our customer service team.